Manual

SaMOG Administration Guide, StarOS Release 17 ▄
77
Chapter 4
Monitoring the SaMOG Gateway
This chapter provides information for monitoring the status and performance of the SaMOG (S2a Mobility Over GTP)
Gateway using the show commands found in the CLI (Command Line Interface). These command have many related
keywords that allow them to provide useful information on all aspects of the system ranging from current software
configuration through call activity and status.
The selection of show commands listed in this chapter is intended to provided the most useful and in-depth information
for monitoring the system. For additional information on these and other show commands and keywords, refer to the
Command Line Interface Reference.
The system also supports the sending of Simple Network Management Protocol (SNMP) traps that indicate status and
alarm conditions. See the SNMP MIB Reference for a detailed listing of these traps.