Troubleshooting Guide

These circuits are deleted and recreated in the final step of this procedure. This task is best
accomplished from the shelf view of the node (Node4) to be removed.
At the Shelf view, click Circuits and ensure that the Scope is set to Node from the drop down menu.
This allows you to only see circuits that pass through or drop at this node.
5.
Individually highlight each circuit and click Edit.
From the Edit window make sure the Show Detailed Map box is checked. You should now see on
which STS and VT the circuit enters and leaves the node. If these do not match then document the
circuit for deletion and recreation in the final step 15 of this procedure.
6.