Technical References

To further determine which command or autonomous message you need, identify what category the

action applies to (i.e. BLSR, Cross Connections). In the Cisco ONS SONET TL1 Command Guide,

commands and autonomous messages are categorized based on the area of the NE that they effect. For

example, if you want to create, edit, or delete a cross-connection, you will find the available commands

in the Cross Connections category. Table 2 shows some examples of actions, categories, and

commands that apply to the Cisco ONS 15454, ONS 15310-CL, ONS 15310-MA, and ONS 15600.

For a complete list of categories, commands and autonomous messages, refer to the Cisco ONS

SONET TL1 Command Guide.

Table 1 TL1 Command and Autonomous Message Actions

Commands or Autonomous

Messages That Begin With Generally Do This Command Example

ACT- Activate ACT-USER

ALW- Allow ALW-MSG-ALL

APPLY Apply APPLY

CANC (autonomous message) Report CANC (reports a cancelled session)

CANC- Cancel CANC-USER

CHG- Change CHG-ACCMD-<MOD_TACC>

CLR- Clear CLR-COND-SECU

CONN- Connect CONN-TACC-<MOD_TACC>

COPY- Copy COPY-IOSCFG

DISC- Disconnect DISC-TACC

DLT- Delete DLT-BLSR

ED- Edit/Change ED-BITS

ENT- Enter/Create ENT-BLSR

EX- Exercise EX-SW-<OCN_BLSR>

INH- Inhibit INH-MSG-ALL

INIT- Initialize INIT-SYS

OPR- Operate/Create OPR-LNK

REPT (autonomous message) Report REPT ALM ENV

RLS- Release RLS-EXT-CONT

RMV- Remove RMV-<MOD2>

RST- Restore RST-<MOD2>

RTRV- Retrieve RTRV-COND-RING

SCHED- Schedule SCHED-PMREPT-<MOD2>

SET- Set SET-ATTR-ENV

SW- Switch SW-DX-EQPT

TST- Test TST-INSERRBITS-<MOD2>