Technical References

22
RLS-LPBK-<MOD2>:[<TID>]:<SRC>:<CTAG>::[<LOCATION>],,,[<LPBKTYPE>];
• TID is the name of the node you want to access. If you only want to query the node you connected
to leave the TID blank.
• SRC is an access identifier. Valid values are facility, DS1, and STS.
• CTAG is any non-blank character series that does not have to be unique.
• LOCATION is the location where the operation is to be carried out.
• LPBKTYPE is a loopback type and is optional. LPBKTYPE can be FACILITY or TERMINAL.
Input Example:
RLS-LPBK-T1::FAC-17-2:34::,,,FACILITY;
Log Out of TL1
When you are finished using TL1, you must log out of the session. Logging out of TL1 only has to be
done once per session.
Step 1 If you logged into TL1 via CTC, you must log out by pressing the Disconnect button or by
issuing the CANC-USER command as shown in the following steps.
If you logged into TL1 via Telnet or craft interface, you must log out by issuing the
CANC-USER command.
Input Format:
CANC-USER:[<TID>]:<USERID>:<CTAG>;
• TID is the name of the node you want to access. If you only want to query the node you
connected to leave the TID blank.
• USERID is your user ID. Maximum of 10 alphanumeric characters.
• CTAG is any non-blank character series that does not have to be unique.
Input Example:
CANC-USER:PETALUMA:DXT:100;
Step 2 Confirm you receive a COMPLD response to indicate the command was completed
successfully.
Response Example:
TID001 03-07-22 02:45:12
M 100 COMPLD
;