Technical References

11
TACC defines the STS as a test access port with a selected unique TAP number. The TAP number
is in the range of 0, 1–999. When TACC is 0 (zero), the TAP is deleted.
TAPTYPE is the test access point type. Values are DUAL or SINGLE.
SOAK is IS-AINS to IS transition soak time as measured in 15 minute intervals, so a value of 4
translates to a soak time of 1 hour. The allowable range is 0–192 intervals (maximum of 48 hours).
SFBER identifies port SFBER; valid values are 1E-3, 1E-4 or 1E-5.
SDBER identifies port SDBER; valid values are 1E-5, 1E-6,...1E-9.
SYNCMSG is the synchronization status message. Values are NO or YES.
SENDDUS is the synchronization status message Don’t use for Synchronization (DUS). Optional
for ONS 15454 and ONS 15310-CL/MA, and ONS 15600.
NAME is the name. Maximum length is 32 characters.
MODE type of DS1MODE.
SYNCMAP is the synchronization mapping for the DS1 facility. Only supported on ONS 15454.
ADMSSM is the administration synchronization status message. Only supported on ONS 15454
and ONS 15600.
VTMAP is the port to VT mapping type for that particular STS. Only supported on ONS 15454.
INHFELPBK indicates whether far end loopbacks are inhibited on the facility. Only supported on
ONS 15454.
AISONLPBK is the AIS to be sent on what type of loopback.
CMDMDE is the command mode. Values are FRCD or NORM.
AISVONAIS is enabled or disabled.
AISONLOF is enabled or disabled.
BERTMODE specifies the mode [Test Pattern Generator (TPG) or Test Pattern Monitor (TPM)]
of the port for BERT.
BERTPATTERN specifies the error pattern to be injected for BERT.
BERTERRCOUNT is the integer value. Value –1 indicates that BERT is disabled/not supported.
PST is primary state. Values are IS or OOS.
SST is secondary state. Values are MT or AINS.
Input Example:
ED-T1:CISCO:FAC-2-1:1223:::LINECDE=AMI,FMT=ESF,LBO=0-131,TACC=8,TAPTYPE=SINGLE
,SOAK=10,SFBER=1E-4,SDBER=1E-6,SYNCMSG=Y,SENDDUS=Y,NAME="T1
PORT",CMDMDE=FRCD,AISONLPBK=AIS_ON_LPBK_ALL,MODE=FDL,SYNCMAP=ASYNC,A
DMSSM=STU,VTMAP=GR253,AISVONAIS=Y,AISONLOF=Y,INHFELPBK=N,
BERTMODE=NONE,BERTPATTERN=NONE,BERTERRCOUNT=0:IS,AINS;