Technical References

10
To retrieve all alarms on a specific DS1 port see RTRV-ALM-T1, page 14.
To retrieve all conditions on a specific DS1 port see RTRV-COND-T1, page 15.
To retrieve all alarms on a system see RTRV-ALM-ALL, page 16.
To retrieve all conditions on a system see RTRV-COND-ALL, page 17.
To retrieve actual PM values on a DS1 port see RTRV-PM-T1, page 19.
To retrieve the thresholds in place for a DS1 port see RTRV-TH-T1, page 20.
To create a loopback see OPR-LPBK-T1, page 21.
To release a loopback see RLS-LPBK-T1, page 21.
Note When you are finished using TL1 remember to log out. Follow the steps in the “Log Out of
TL1” section on page 22 to log out.
For complete TL1 documentation, refer to the Cisco ONS SONET TL1 Command Guide and the
Cisco ONS SONET TL1 Reference Guide. For a command quick reference guide, refer to the Cisco
ONS SONET TL1 Command Quick Reference Guide.
ED-T1
Use the ED-T1 command edits the attributes related to a DS1/T1 port. ED-T1 is from the Ports
category.
Input Format:
ED-T1:[<TID>]:<AID>:<CTAG>[:::LINECDE=<LINECDE>],[FMT=<FMT>],[LBO=<LBO>],
[TACC=<TACC>],[TAPTYPE=<TAPTYPE>],[SOAK=<SOAK>],[SFBER=<SFBER>],
[SDBER=<SDBER>],[SYNCMSG=<SYNCMSG>],[SENDDUS=<SENDDUS>],[NAME=<NAME>],
[CMDMDE=<CMDMDE>],[AISONLPBK=<AISONLPBK>],[MODE=<MODE>],
[SYNCMAP=<SYNCMAP>],[ADMSSM=<ADMSSM>],[VTMAP=<VTMAP>],
[AISVONAIS=<AISVONAIS>],[AISONLOF=<AISONLOF>],[INHFEBPLPBK=<INHFEBPLPBK>],
[BERTMODE=<BERTMODE>],[BERTPATTERN=<BERTPATTERN>],
[BERTERRCOUNT=<BERTERRCOUNT>][:<PST>[,<SST>]];
TID is the name of the node you want to access. If you only want to query the node you connected
to leave the TID blank.
AID is the access identifier to indicate slot and port.
CTAG is any non-blank character series that does not have to be unique.
LINECDE is a line code. Values are AMI or B8ZS.
FMT is a frame format. Values are D4, ESF, or unframed.
LBO is a line build out. Values are 0-131, 132-262, 263-393, 394-524, or 525-655.