Maintenance Manual

Getting Started

Installing the Disk Drives

Cisco Small Business NSS300 Series Smart Storage Administration Guide 20

To install disk drives in the NAS chassis:

STEP 1 Remove the contents of the NAS package from the box.

STEP 2 Place the chassis upright on a flat surface.

STEP 3 From disk bay 1, remove the disk tray.

To remove the disk tray, push down the silver tab to unlock the tray, and push the

lower tab to release the tray lever. Using the tray lever, pull out the tray.

NOTE If your device already has the disk drives installed, continue to the next section,

Connecting the Equipment, page 23.

STEP 4 Position the disk drive into a disk tray. The electrical connectors of the disk drive

must face toward the back of the drive tray.

STEP 5 Attach the disk drive to the tray by inserting the disk drive screws into the four

holes at the bottom of the tray and tightening them with a Phillips screwdriver.

NOTE Use the screws provided in the box with the device. Using other screws can cause

damage to your disk or disk tray.

There are clearly marked disk holes to accommodate the following disk drives:

• 3.5-inch disk drive (use the included silver screws)

• 2.5-inch disk drive (use the included black screws)

ENTER

277516

ENTER

SELECT

STATUS LAN USB eSATA

NSS 326

Smart Storage