Maintenance Manual

Managing the System

Disk Management

Cisco Small Business NSS300 Series Smart Storage Administration Guide 127

STEP 5 Click the Target Management tab to create iSCSI targets on the NAS. If you have

not created any iSCSI targets, the Quick Configuration Wizard appears.

STEP 6 Click OK to launch the wizard.

STEP 7 From the iSCSI Quick Configuration Wizard window options, click iSCSI Target

with a mapped LUN, then click Next.

STEP 8 Click Next again and the wizard will guide you through:

• Creating an iSCSI target

• Creating an iSCSI LUN and mapping it to the target

STEP 9 From the Create New iSCSI Target window, enter the following parameters:

iSCSI Target Profile:

• Target Name—Enter the target name for the iSCSI storage resource.

• Target Alias—Enter the target alias for the iSCSI storage resource.

CRC/Checksum (Optional):

• Data Digest—Click to use the data digest procedure when identifying and

verifying the checksum.

• Header Digest—Click to use the header digest procedure when identifying

and verifying the checksum.

STEP 10 Click Next to continue to the authentication settings.

STEP 11 From the CHAP Authentication Settings window, enter the following parameters:

• Use CHAP authentication—Select to enable CHAP authentication. Using

CHAP authentication, only the iSCSI target authenticates the initiator. For

example, the initiators have to enter the user name and password setting

here to access the target.

• User Name—Enter the user name for CHAP authentication. Maximum

length is 256 characters.

• Password—Enter the password. Maximum length is 12-16 characters.

• Re-enter Password—Re-enter the password for verification.

• Mutual CHAP—Click to use the CHAP two-way authentication protocol

between the iSCSI target and initiator. The target authenticates the initiator

using the first set of username and password. The initiator authenticates the

target using the mutual CHAP settings.