Technical References

Specifies the prefix length of the reverse zone for ip6.arpa
updates. You do not need to specify the full reverse zone,
because you can synthesize it by using the ip6.arpa domain.
Use a multiple of 4 for the value, because ip6.arpa zones
are on 4-bit boundaries. If not a multiple of 4, the value
is rounded up to the next multiple of 4.
The maximum value is 124, because specifying 128 would
create a zone name without any possible hostnames
contained within.
A value of 0 means none of the bits are used for the zone
name, hence ip6.arpa is used.
If you omit the value from the DNS update configuration,
the server uses the value from the prefix or, as a last
resort, the prefix length derived from the address value
of the prefix.
selection-tags string
Associates selection tags with an IPv6 prefix (subnet).
vpn-id int default = 0, immutable
Identifies the VPN that contains an IPv6 prefix.
prefix-policy
prefix-policy - Edits a DHCP policy embedded in a prefix
Note: dhcp-prefix-policy is a synonym for compatibility with earlier
versions of Network Registrar.
Synopsis
prefix-policy <name> delete
prefix-policy <name> set <attribute>=<value>
[<attribute>=<value> ...]
prefix-policy <name> get <attribute>
prefix-policy <name> disable <feature>
prefix-policy <name> enable <feature>
prefix-policy <name> show
prefix-policy <name> setV6Option <opt-name | id> <value>
prefix-policy <name> getV6Option <opt-name | id>
prefix-policy <name> unsetV6Option <opt-name | id>
prefix-policy <name> listV6Options
prefix-policy <name> setV6VendorOption <opt-name | id>
<opt-set-name> <value>
prefix-policy <name> getV6VendorOption <opt-name | id>
<opt-set-name>
prefix-policy <name> unsetV6VendorOption <opt-name | id>
<opt-set-name>
prefix-policy <name> listV6VendorOptions
Description