Release Notes

Send documentation comments to [e-mail]
19
)Cisco MDS 9000 Family Release Notes for Cisco MDS NX-OS Release 5.0(1a)
OL-21012-01
Upgrading Your Cisco MDS NX-OS Software Image
Upgrading with IVR Enabled
An Inter-Switch Link (ISL) flap resulting in fabric segmentation or a merge during or after an upgrade
from Cisco MDS SAN-OS Release 2.0(x) to a later image where IVR is enabled might be disruptive.
Some possible scenarios include the following:
• FCIP connection flapping during the upgrade process resulting in fabric segmentation or merge.
• ISL flap results in fabric segmentation or merge because of hardware issues or a software bug.
• ISL port becomes part of PCP results in fabric segmentation or merge because of a port flap.
If this problem occurs, syslogs indicate a failure and the flapped ISL could remain in a down state
because of a domain overlap.
This issue was resolved in Cisco SAN-OS Release 2.1(2b); you must upgrade to Release 2.1(2b) before
upgrading to Release 3.3(1c). An upgrade from Cisco SAN-OS Releases 2.1(1a), 2.1(1b), or 2.1(2a) to
Release 2.1(2b) when IVR is enabled requires that you follow the procedure below. If you have VSANs
in interop mode 2 or 3, you must issue an IVR refresh for those VSANs.
To upgrade from Cisco SAN-OS Releases 2.1(1a), 2.1(1b), or 2.1(2a) to Release 2.1(2b) for all other
VSANs with IVR enabled, follow these steps:
Step 1 Configure static domains for all switches in all VSANs where IVR is enabled. Configure the static
domain the same as the running domain so that there is no change in domain IDs. Make sure that all
domains are unique across all of the IVR VSANs. We recommend this step as a best practice for
IVR-non-NAT mode. Issue the fcdomain domain id static vsan vsan id command to configure the static
domains.
Note Complete Step 1 for all switches before moving to Step 2.
Step 2 Issue the no ivr virtual-fcdomain-add vsan-ranges vsan-range command to disable RDI mode on all
IVR enabled switches. The range of values for a VSAN ID is 1 to 4093. This can cause traffic disruption.
Note Complete Step 2 for all IVR enabled switches before moving to Step 3.
Step 3 Check the syslogs for any ISL that was isolated.
2005 Aug 31 21:52:04 switch %FCDOMAIN-2-EPORT_ISOLATED:
%$VSAN 2005%$ Isolation of interface
PortChannel 52 (reason: unknown failure)
2005 Aug 31 21:52:04 switch %FCDOMAIN-2-EPORT_ISOLATED: %$VSAN 2005%$
Isolation of interface PortChannel 51
(reason: domain ID assignment failure)
Step 4 Issue the following commands for the isolated switches in Step 3:
switch(config)# vsan database
switch(config-vsan-db)# vsan vsan-id suspend
switch(config-vsan-db)# no vsan vsan-id suspend
Step 5 Issue the ivr refresh command to perform an IVR refresh on all the IVR enabled switches.
Step 6 Issue the copy running-config startup-config command to save the RDI mode in the startup
configuration on all of the switches.