Technical Manual

T308 = 4.000 seconds
T309 Disabled
T310 = 60.000 seconds
T313 = 4.000 seconds
T316 = 120.000 seconds
Note: In Cisco CallManager version 3.x, due to operator implementations in some countries, you can be
required to include a "sending complete indicator". This parameter is located in the Cisco CallManager
parameters page.
Note: By default, in Cisco CallManager version 4.x, all outbound calls through a PRI interface that use an
ETSI−based protocol type include sending a complete indicator in the outgoing SETUP message. This
indicates effectively that all these outbound calls use Enbloc signaling, not overlap sending procedures for call
setup. Due to operator implementations in some countries, it can possibly be required to enable overlap
sending. In order to do this, check the Allow Overlap Sending check box in the Route Pattern configuration
page.
Related Information
Voice Technology Support•
Voice and Unified Communications Product Support•
Troubleshooting Cisco IP Telephony •
Technical Support − Cisco Systems•