Manual

1-, 2-, and 4-Port T1/E1 HWICs and 8-Port T1/E1 Network Module
controller
19
Cisco IOS Release 12.4(11)XW5, and 12.4(20)T
controller
To configure a T1, E1, or J1 controller and enter controller configuration mode, use the controller
command in global configuration mode.
Cisco 2600 and 3600 Series Routers
controller {t1 | e1 | j1} slot/port
Cisco 7200 Series and Cisco 7500 Series Routers
controller {t1 | e1} slot/port
Cisco AS5300 Access Servers
controller {t1 | e1} number
Cisco AS5800 Access Servers
controller t1 dial-shelf/slot/t3-port:t1-num
Cisco 2800 and 3800 Series Routers
controller {t1 | e1} slot/subslot/port
Syntax Description
Defaults No T1, E1, or J1 controller is configured.
Command Modes Global configuration
t1 T1 controller.
e1 E1 controller.
j1 J1 controller.
slot/port Backplane slot number and port number on the interface. Refer to your hardware
installation manual for the specific values and slot numbers.
slot/subslot/port Backplane slot number, subslot number, and port number on the interface. Refer to
your hardware installation guide for the specific values, and slot and subslot
numbers.
number Network processor module (NPM) number, in the range 0 through 2.
dial-shelf Dial shelf chassis in the Cisco AS5800 access server that contains the interface
card.
/t3-port T3 port number. The only valid value is 0.
:t1-num T1 timeslot in the T3 line. The value can be from 1 to 28.