Manual

Cisco Packet Data Serving Node (PDSN) Release 2.0
Configuration Examples
79
12.3(11)T
no login
line vty 1 4
login
line vty 5 15
login
!
end
S96#
Verify active controller and standby controller
S76#sh standby
GigabitEthernet0/0.401 - Group 1
State is Active
2 state changes, last state change 00:27:09
Virtual IP address is 10.121.68.98
Active virtual MAC address is 0000.0c07.ac01
Local virtual MAC address is 0000.0c07.ac01 (default)
Hello time 3 sec, hold time 10 sec
Next hello sent in 2.112 secs
Preemption enabled, min delay 0 sec, sync delay 0 sec
Active router is local
Standby router is 10.121.68.96, priority 120 (expires in 9.064 sec)
Priority 120 (configured 120)
IP redundancy name is "6509-cluster"
S76#
S96#sh standby
GigabitEthernet0/0.401 - Group 1
State is Standby
1 state change, last state change 00:26:57
Virtual IP address is 10.121.68.98
Active virtual MAC address is 0000.0c07.ac01
Local virtual MAC address is 0000.0c07.ac01 (default)
Hello time 3 sec, hold time 10 sec
Next hello sent in 2.532 secs
Preemption enabled, min delay 0 sec, sync delay 0 sec
Active router is 10.121.68.76, priority 120 (expires in 9.580 sec)
Standby router is local
Priority 120 (configured 120)
IP redundancy name is "6509-cluster"
S96#
Members configuration:
cat6500 router#session slot 7 processor 3
The default escape character is Ctrl-^, then x.
You can also type 'exit' at the remote prompt to end the session
Trying 127.0.0.73 ... Open
S73>
Press RETURN to get started!
S73>
S73>en
S73#sh run
S73#sh running-config
Building configuration...
Current configuration : 3192 bytes