Manual

Cisco Packet Data Serving Node (PDSN) Release 2.0
Configuration Examples
76
12.3(11)T
PDSN Cluster Configuration
The following configuration illustrates 3 MWAMs in a 6500 configuration:
Verify hardware configuration on Cat6K:
cat6500 router#sh module
Mod Ports Card Type
----------------------------------------------
1 2 Catalyst 6000 supervisor 2 (Active)
3 48 SFM-capable 48-port 10/100 Mbps RJ45
4 2 IPSec VPN Accelerator
5 16 SFM-capable 16 port 1000mb GBIC
7 3 MWAM Module
8 3 MWAM Module (MP)
9 3 MWAM Module
Mod MAC addresses Hw Fw Sw Status
--- ---------------------------------- ------ ------------ ------------ -------
1 0005.7485.8494 to 0005.7485.8495 3.5 6.1(3) 6.2(2.108) Ok
3 0001.63d7.2352 to 0001.63d7.2381 4.2 6.3(1) 6.2(2.108) Ok
4 0008.7ca8.1386 to 0008.7ca8.1389 0.200 7.2(1) 6.2(2.108) Ok
5 0001.63d6.cd92 to 0001.63d6.cda1 4.1 6.3(1) 6.2(2.108) Ok
7 0001.0002.0003 to 0001.0002.000a 0.203 7.2(1) 1.0(0.1) Ok
8 00e0.b0ff.3a10 to 00e0.b0ff.3a17 0.201 7.2(1) 1.2(0.12) ShutDown
9 0002.0002.0003 to 0002.0002.000a 0.203 7.2(1) 1.0(0.1) Ok
Mod Sub-Module Hw Status
--- --------------------------- ------- -------
1 Policy Feature Card 2 3.2 Ok
1 Cat6k MSFC 2 daughterboard 2.2 Ok
cat6500 router#
Controller configuration:
cat6500 router#session slot 7 processor 6
The default escape character is Ctrl-^, then x.
You can also type 'exit' at the remote prompt to end the session
Trying 127.0.0.76 ... Open
Press RETURN to get started!
S76>
S76>
S76>
S76>en
S76#sh run
S76#sh running-config
Building configuration...
Current configuration : 1489 bytes
!
! No configuration change since last restart
!
version 12.2
service timestamps debug uptime
service timestamps log uptime
no service password-encryption
service cdma pdsn
!
hostname S76
!
!