Manual
Cisco Packet Data Serving Node (PDSN) Release 2.0
Configuration Tasks
67
12.3(11)T
Configuring PoD on the PDSN
To enable Packet of Disconnect on the PDSN, perform the following task:
Configuring Mobile IP Resource Revocation on the PDSN
To enable resource revocation support on PDSN, perform the following task:
Configuring PDSN Accounting Events
To configure attributes of PDSN accounting events, use the following commands in global configuration
mode:
Command Purpose
Router(config)# cdma pdsn radius disconnect
Enables the RADIUS disconncect feature on the
PDSN.
Router(config)# aaa pod server [clients ipaddr1 [ipaddr2]
[ipaddr3] [ipaddr4]] [port port-number] [auth-type {any | all
| session-key}] server-key [encryption-type] string
AAA command that enables listening for POD
packets.
Command Purpose
Router(config)# ip mobile foreign-service revocation [timeout
value] [retransmit value] [timestamp]
timeout value is the time interval in seconds
between re-transmission of resource revocation
message. The wait time is between 0-100, and the
default value is 3 seconds.
retransmit value is the number of maximum
re-transmissions of MIPv4 resource revocation
messages.
The number of retries for a transaction is 0-100.
The default value is 3.
Note All foreign-service configurations should
be done globally and not under the
virtual-template interface.
Timestamp specifies the unit of timestamp field
for revocation. The unit of timestamp value for
revocation is in milliseconds.
Command Purpose
Router(config)# clock timezone zone hours-offset
[minutes-offset]
Sets the time zone for display purposes.
Router(config)# cdma pdsn accounting local-timezone
Sets the local time stamp for PDSN accounting
events.