Manual

Cisco Packet Data Serving Node (PDSN) Release 2.0
Configuration Tasks
52
12.3(11)T
Configuration Tasks
This section describes the steps for configuring the Cisco PDSN software on both the 7200 and MWAM
platforms. Prior to configuring instances of the PDSN on MWAM application cards, you must create a
base Catalyst 6500 or 7600 configuration. Refer to the Cisco Multi-processor WAN Application Module
Installation and Configuration Note for more information.
Configuring the PDSN Image
The Cisco PDSN can provide four classes of user services: Simple IP, Simple IP with VPDN, Mobile IP,
and proxy Mobile IP. The following sections describe the configuration tasks for implementing Cisco
PDSN. Each category of tasks indicates whether the tasks are optional or required.
R-P Interface Configuration Tasks (Required for all classes of user services)
The following tasks establish the R-P interface, also referred to as the A10/A11 interface. Configuring
the R-P interface is required in all 7200 platform configuration scenarios.
To configure the R-P interface, complete the following tasks:
• Enabling PDSN Services
• Creating the CDMA Ix Interface
• Creating a Loopback Interface
• Creating a Virtual Template Interface and Associating It With the PDSN Application
• Enabling R-P Interface Signaling
User Session Configuration Tasks (Optional)
To configure the user session, complete the following task.
• Configuring User Session Parameters
AAA and RADIUS Configuration Tasks (Required for All Scenarios)
To configure the AAA and RADIUS in the PDSN environment, complete the following tasks.
• Configuring AAA in the PDSN Environment
• Configuring RADIUS in the PDSN Environment
Prepaid Configuration Tasks (Available only on C-6 images)
• Configuring Prepaid in the PDSN Environment
VPDN Configuration Tasks (Required for Simple IP with VPDN Scenario)
To configure the VPDN in the PDSN environment, complete the following task:
• Enabling VPDN in a PDSN Environment