Manual

Cisco Packet Data Serving Node (PDSN) Release 2.0
Resource Management
41
12.3(11)T
Conditional debugging is an IOS feature, and the following CLI are available across all images.
router# debug condition ?
application Application
called called number
calling calling
glbp interface group
interface interface
ip IP address
mac-address MAC address
match-list apply the match-list
standby interface group
username username
vcid VC ID
The options calling, username, and ip are used by the CDMA/Mobile IP subsystems.
PDSN#debug condition username ?
WORD Username for debug filtering
PDSN#debu condition calling ?
WORD Calling number
PDSN#debu condition ip ?
A.B.C.D IP address
Refer to the Debug Commands section of this document for more information about conditional
debugging in PDSN Release 2.0.
Electronic Serial Number (ESN) in Billing
The ESN is a unique identifier for a piece of equipment, such as of a mobile device, and is used during
the authentication process. The ESN is parameter a2 of the R-P Session Setup airlink record, and
parameter A2 in the PDSN Usage Data Record (UDR). Both parameters are introduced in this release.
The PDSN accepts the parameter a2, and puts it as A2 into a User Data Record.
This feature is supported in the Cisco Access Registrar.
1xEV-DO Support
The Cisco PDSN supports Evolution-Data Optimized (1xEV-DO). 1xEV-DO offers high performance,
high-speed, high-capacity wireless Internet connectivity, and is optimized for packet data services. It can
transport packet data traffic at forward peak rates of 2.4 Mbps, which is much higher than the current
1xRTT peak rate of 144 kbps.
PDSN support for 1xEV-DO technology includes the following enhancements:
• PDSN recognizes a new Service Option value of 59 (decimal) for 1xEV-DO in Active Start Airlink
Record.
• The PDSN CLI commands are enhanced to show sessions—show cdma pdsn session—so that
packet service options are displayed (1xRTT, 1xEV-DO, or undefined).