Manual

Layer 2 Tunnel Protocol Version 3
debug xconnect
87
Cisco IOS Releases 12.0(29)S and 12.2(25)S
debug xconnect
To debug a problem related to the Xconnect configuration, use the debug xconnect command in
privileged EXEC mode. To disable the debug xconnect command, use the no form of this command.
debug xconnect {error | event}
no debug xconnect {error | event}
Syntax Description
Command Modes Privileged EXEC
Command History
Usage Guidelines Use this command to display debugging information about Xconnect sessions.
Examples The following example shows output from the debug xconnect command for a Xconnect session on an
Ethernet interface. The output is self-explanatory.
Router# debug xconnect
00:01:16: XC AUTH [Et2/1, 5]: Event: start xconnect authorization, state changed from IDLE
to AUTHORIZING
00:01:16: XC AUTH [Et2/1, 5]: Event: found xconnect authorization, state changed from
AUTHORIZING to DONE
00:01:16: XC AUTH [Et2/1, 5]: Event: free xconnect authorization request, state changed
from DONE to END
Related Commands
error Displays errors related to an Xconnect configuration.
event Displays events related to an Xconnect configuration processing.
Release Modification
12.0(23)S This command was introduced.
12.2(25)S This command was integrated into Cisco IOS Release 12.2(25)S.
Command Description
debug acircuit Displays events and failures related to attachment circuits.
debug vpdn Displays errors and events relating to L2TP configuration and the
surrounding Layer 2 tunneling infrastructure.