Manual

Layer 2 Tunnel Protocol Version 3
debug atm cell-packing
84
Cisco IOS Releases 12.0(29)S and 12.2(25)S
debug atm cell-packing
To enable the display of ATM cell relay cell-packing debugging information, use the debug atm
cell-packing command in privileged EXEC mode. To disable the display of debugging information, use
the no form of this command.
debug atm cell-packing
no debug atm cell-packing
Syntax Description This command has no arguments or keywords.
Defaults Debugging of the cell-packing feature is not enabled.
Command Modes Privileged EXEC
Command History
Examples The following example enables debugging for ATM virtual circuits (VCs) that have been configured with
cell packing:
Router# debug atm cell-packing
ATM Cell Packing debugging is on
00:09:04: ATM Cell Packing: vc 1/100 remote mncp 22 validated
The following example enables debugging for permanent virtual paths (PVPs) that have been configured
with cell packing:
Router# debug atm cell-packing
ATM Cell Packing debugging is on
00:12:33: ATM Cell Packing: vp 1 remote mncp 22 validated
The output indicates that the router received the MNCP information from the remote PE router.
Related Commands
Release Modification
12.0(25)S This command was introduced.
Command Description
atm mcpt-timers Creates cell-packing timers that specify how long the PE router can wait for
cells to be packed into an MPLS or L2TPv3 packet.
cell-packing Enables the packing of multiple ATM cells into a single MPLS or L2TPv3
packet.
show atm cell-packing Displays information about the VCs and VPs that have ATM cell relay over
MPLS or L2TPv3 cell packing enabled.