Manual

Layer 2 Tunnel Protocol Version 3
show atm cell-packing
132
Cisco IOS Releases 12.0(29)S and 12.2(25)S
show atm cell-packing
To display information about the virtual circuits (VCs) and virtual paths (VPs) that have ATM cell relay
cell packing enabled, use the show atm cell-packing command in privileged EXEC mode.
show atm cell-packing
Syntax Description This command has no arguments or keywords.
Command Modes privileged EXEC
Command History
Usage Guidelines The number of packed cells need not match between the provider edge (PE) routers. The two PE routers
agree on the lower of the two values. For example, if PE1 is allowed to pack 10 cells per Multiprotocol
Label Switching (MPLS) packet and PE2 is allowed to pack 20 cells per MPLS packet, the two PE
routers would agree to send no more than 10 cells per packet.
Examples The following show atm cell-packing command displays VCs and VPs that have cell packing enabled:
Router# show atm cell-packing
average average
circuit local nbr of cells peer nbr of cells MCPT
type MNCP rcvd in one pkt MNCP sent in one pkt (us)
==============================================================================
atm 1/0 vc 1/200 20 15 30 20 60
Table 8 describes the significant fields shown in the display.
Release Modification
12.0(25)S This command was introduced.
Table 8 show atm cell-packing Field Descriptions
Field Description
circuit type Interface and VC or VP designators.
local MNCP Maximum number of cells packed (MNCP) on the local PE
router.
average nbr of cells rcvd in one pkt Average number of cells that the PE router receives.
peer MNCP MNCP of the peer PE router.