Manual

Layer 2 Tunnel Protocol Version 3
pseudowire-class
125
Cisco IOS Releases 12.0(29)S and 12.2(25)S
pseudowire-class
To specify the name of a Layer 2 Tunnel Protocol Version 3 (L2TPv3) pseudowire class and enter
pseudowire class configuration mode, use the pseudowire-class command in global configuration mode.
pseudowire-class [pw-class-name]
Syntax Description
Defaults No pseudowire class is defined.
Command Modes Global configuration
Command History
Usage Guidelines The pseudowire-class command allows you to configure a pseudowire class template that consists of
configuration settings used by all attachment circuits bound to the class. A pseudowire class includes the
following configuration settings:
• Data encapsulation type
• Control protocol
• Sequencing
• IP address of the local L2TPv3 interface
• Type of Service (ToS) value in IP headers
After you enter the pseudowire-class command, you switch to pseudowire class configuration mode,
where pseudowire settings may be configured.
Examples The following example shows how to enter pseudowire class configuration mode to configure a
pseudowire configuration template named ether-pw:
Router(config)# pseudowire-class ether-pw
pw-class-name (Optional) The name of a L2TP pseudowire class. If you want to configure
more than one pseudowire class, you must enter a value for the
pw-class-name argument.
Release Modification
12.0(23)S This command was introduced.
12.2(25)S This command was integrated into Cisco IOS Release 12.2(25)S.