Installation Guide

7-8
Cisco Intelligent Automation for Cloud Installation Guide
OL-29971-02
Chapter 7 Configuring Cisco IAC With the Wizard
Configuring Agent Properties
Starting a DB Agent
Follow these steps to enter credentials for connecting to the database.
Step 1 From the Wizard, choose Start DB Agent.
Step 2 Navigate to the page with the agent.
Step 3 On the Control Agents Tab of the Service Links portal, choose Insert Default Parameters.
Step 4 Click Start Chosen, and then click Ye s to confirm.
Step 5 Refresh the page and the red light icon next to Insert Default Parameters will turn green.
Step 6 Choose Portal Page Assignment to OU.
Step 7 Navigate to the page with that agent.
Step 8 Click Start Chosen, and then click Yes to confirm.
Step 9 Refresh the page until the red light icon next to Portal Page Assignment to OU turns green.
Step 10 Click Close.
Configuring the nsAPI Agent
To configure the nsAPI agent:
Step 1 From the Wizard, choose Configure NSAPI Agent.
Step 2 On the Set Agent Configuration form, complete the following:
• Set Agent Type to NSAPI (may already be set; be sure to check).
• Choose Basic as the Authentication Scheme.
Note This value must be set to “Basic,” otherwise nsAPI will not function correctly and you will
not be able to properly continue Day 0 setup.
• Enter the nsAPI username and password (as created earlier).
• Reenter the password to confirm.
Step 3 Click Submit Order.
Note Monitor this requisition to be sure it completes. Refresh as needed. Only move on once you are
certain that the requisition has completed.