Installation Guide

CHAPTER

3-1

Cisco Intelligent Automation for Cloud Installation Guide

OL-29971-02

Installing Cisco IAC PO Automation Packs

In this chapter, you will find instructions for installing the following automation packs:

• Intelligent Automation for Cloud Extension Samples.tap (optional but recommended)

• Intelligent Automation for Cloud Starter.tap

• Intelligent Automation for Cloud.tap

• Intelligent Automation for Compute.tap

Note You first need to install Cisco Process Orchestrator 3.1. For full instructions, refer to the Cisco Process

Orchestrator documentation, located here:

http://www.cisco.com/c/en/us/support/cloud-systems-management/process-orchestrator/tsd-products-s

upport-series-home.html

Launching the Setup Wizard

Step 1 Download the Cisco IAC 4.1.1 installer. The IAC 4.1.1 PO content files are part of the build file named

IAC 4.1.1.xxxx.

Note To find the latest file, navigate to http://software.cisco.com. Find the downloads link and look

for Cisco Intelligent Automation for Cloud as the software.

Step 2 Un-zip IAC4.1.1.xxx.

Step 3 Locate the Cisco IAC 4.1.1 setup.exe file and run it to start the Setup Wizard.

• Click Next to proceed to the next step.

Step 4 On the Information page, click Next again to continue.

Step 5 On the Confirm Installation page, click Next to continue.

Step 6 On the Installation Complete page, check the Launch automation pack import wizard now check box.

Step 7 Click Close to launch the Automation Pack Import Wizard. The Import Wizard will first configure itself.