Installation Guide

G-3
Cisco Intelligent Automation for Cloud Installation Guide
OL-29971-02
Appendix G Upgrading Cisco PPM to the Full License
/opt/CSCOppm-gw/bin/ppm backup
Step 3 Validate that the backup file(s) were created.
Note The default location of the files is /opt.
Examples of files created:
• ppm15-Unit-hostname.tar
• ppm15-Gateway-hostname-backup.tar
Step 4 Uninstall Prime Performance Manager 1.5.1 evaluation.
• To uninstall a previous build without any questions:
/opt/CSCOppm-gw/bin/ppm uninstall -n
Step 5 Install 1.5.
• To perform an installation from the directory that contains the PPM installation files:
./setup.sh
Step 6 After the Gateway and Unit are installed, exit the installation.
Note Do NOT yet start the system.
Step 7 Install upgrade to 1.5.1.
• To perform an installation from the directory that contains the PPM installation files:
./setup.sh
Step 8 Start the Gateway and Unit after the installation is complete.
Step 9 Validate the system has been updated and the version is 1.5.1:
/opt/CSCOppm-gw/bin/ppm version
Step 10 Enable SSL and user access after the installation has completed:
• /opt/CSCOppm-gw/bin/ppm ssl enable
Step 11 Enable user access after SSL has been installed:
• Execute /opt/CSCOppm-gw/bin/ppm useraccess enable
• You will be prompted for additional information, as shown:
Please choose the type of authentication to use: [local] linux
Enter username: cisco
Enter First Name : Cisco
Enter Last Name : Administrator
Enter access level for user cisco: 5
Step 12 Perform Prime Performance Manager restore:
/opt/CSCOppm-gw/bin/ppm restore both
Step 13 After the restore completes for the Gateway and Unit start the system
/opt/CSCOppm-gw/bin/ppm start