Technical Manual

Advanced settings are well documented in ISE 2.1 Admin Guide, link can be found in the
References section of this document. Click on Next and Finish. Qualys Instance transitions to
Active state and knowledge base download starts.
Note: There can be only one Qualys instance per deployment.
Step 4. Configure Authorization Profile to trigger VA Scan
Navigate to Policy > Policy Elements > Results > Authorization > Authorization Profiles. Add new
profile. Under Common Tasks select Vulnerability Assessment checkbox.
On-Demand scan interval should be selected according to your network design.
Authorization Profile contains those av-pairs:
cisco-av-pair = on-demand-scan-interval=48
cisco-av-pair = periodic-scan-enabled=0
cisco-av-pair = va-adapter-instance=796440b7-09b5-4f3b-b611-199fb81a4b99