Manual

2-19
ICM-to-ICM Gateway User Guide for Cisco ICM Enterprise & Hosted Editions Release 7.0(0)
Chapter 2 ICM-to-ICM Gateway Configuration
Server Configuration
Configuring the INCRP NIC in ICM Setup
To configure the INCRP NIC on the Server ICM, run ICM Setup and edit the
Router from the Server Router machine (rather than from the installation CD).
Perform the following steps.
Step 1 On the Router Component Properties screen, click the INCRP check box.
Step 2 Click on the Configure button. The INCRP NIC Properties screen appears.
ICM Setup supports a maximum of ten clients.
Step 3 In the Network Interface Controller section of this screen, ensure that the value
for Physical Controller matches the Physical Controller ID value that was
assigned to the NIC when you defined the NIC (see the previous section,
“Installing the INCRP NIC”).