Installation Guide

Step 15
Enter or edit the Local Address, the X25 address of the local computer. The system administrator
provides this value.
Step 16
Enter or edit the Remote Address, the X25 address of the remote switch. The system
administrator provides this value.
Step 17
Click OK.
This accepts the information that you entered, and returns you to the DMS-100 Configuration
dialog box.
Step 18
Enter the TCP Interface Hostname (or IP address) and the TCP Port Number.
Note: After you finish installing the PG, you may wish to install the DMS-100 CompuCALL
Server Gateway.
See Also
For installing the DMS-100 CompuCALL Server Gateway, How to Install a DMS-100
CompuCALL Server Gateway (page 88)
How to Configure the G2 PIM
Step 1
In the G2 Configuration dialog box, to put the PIM into service, check the Enabled option.
This allows the PIM to communicate with the peripheral when the Peripheral Gateway is running.
Step 2
In the Peripheral name field, enter the Peripheral name from the Configuration Manager (use
the PG Explorer tool to view the Peripheral name).
Step 3
In the Peripheral ID field, from the Peripheral record, enter the Peripheral ID value from the
Configuration Manager (use the PG Explorer tool to view the Peripheral ID).
Step 4
In the Application host name field, enter the name of the host computer that passes information
to the PIM.
Step 5
In the Receive connection port field, enter the PG port number on which the PIM receives the
information
How to Configure the Galaxy PIM
Step 1
In the Galaxy Configuration dialog box, to put the PIM into service, check the Enabled option.
This allows the PIM to communicate with the peripheral when the Peripheral Gateway is running.
Step 2
In the Peripheral name field, enter the Peripheral name from the Configuration Manager (use
the PG Explorer tool to view the Peripheral name).
ICM Installation Guide for Cisco ICM Enterprise Edition Release 7.0(0)
75
Peripheral Gateway Setup
How to Configure the G2 PIM