Installation Guide

Step 3
In the Peripheral ID field, from the Peripheral record, enter the Peripheral ID value from the
Configuration Manager (use the PG Explorer tool to view the Peripheral ID).
Step 4
Check CMS Enabled if you plan to use CMS, then fill in the information about the CMS
connection in the Call Management System (CMS) Configuration section. The CMS Data
Timeout is in milliseconds.
Step 5
In the CVLAN Configuration on DLG/BRI CallVisor PC section, enter the requested
information about the CallVisor setup for both sides of a duplexed PG (or only for Side A if
simplexed). In the Minimum number of overall ASAI links before Failover field, enter the
minimum number of Adjunct Switch Application Interface (ASAI) links needed to handle the
expected call load. (Each ASAI link can handle up to 8000 busy hour calls.) For each CallVisor
host, enter the Hostname, and indicate which ASAI links to use. (Each ASAI link connects to
a BRI or Ethernet port on the DEFINITY.)
See Also
For the Peripheral Gateway Component Properties dialog box, How to Set Peripheral Gateway
Component Properties (page 63).
How to Configure the Avaya DEFINITY PIM (using MAPD)
The dialog box you see for DEFINITY ACDs depends on whether or not you chose the Using
MAPD option in the Peripheral Gateway Component Properties dialog box.
If you chose the Using MAPD option, the Definity ECS PIM Configuration (CVLAN on MAPD)
dialog box opens:
Step 1
To put the PIM into service, check the Enabled option. This allows the PIM to communicate
with the peripheral when the Peripheral Gateway is running.
Step 2
In the Peripheral name field, enter the Peripheral name from the Configuration Manager (use
the PG Explorer tool to view the Peripheral name).
Step 3
In the Peripheral ID field, from the Peripheral record, enter the Peripheral ID value from the
Configuration Manager (use the PG Explorer tool to view the Peripheral ID).
Step 4
Use the CVLAN/MAPD Configuration fields to describe the Multi-Application Platform in
Definity (MAP/D) connections for the PG (and its duplexed pair, if any).
Step 5
In the Monitor ASAI links field, indicate which ASAI Links in the MAP/D system the PG will
use for monitoring calls, stations, and so forth. In the Post-Route ASAI links field, indicate
which ASAI Links in the MAP/D system the PG will use for ICM Post-Routingpostroute_def.
In the Heartbeat Maintenance field, indicate which ASAI Links in the MAP/D system the
ICM will use for heartbeat maintenance.
Step 6
In the Minimum number of overall ASAIs links before failover field, indicate the minimum
number of ASAI links required for the expected call load. If the PG is duplexed and the number
ICM Installation Guide for Cisco ICM Enterprise Edition Release 7.0(0)
72
Peripheral Gateway Setup
How to Configure the Avaya DEFINITY PIM (using MAPD)