Installation Guide

How to Configure the Aspect PIM (not using Event Link)

The dialog box you see for Aspect ACDs depends on whether or not you chose Event Link in

the Peripheral Gateway Component Properties dialog box.

If you did not choose Event Link, the Aspect Conﬁguration dialog box opens:

Step 1

To put the PIM into service, check the Enabled option. This allows the PIM to communicate

with the peripheral when the Peripheral Gateway is running.

Step 2

In the Peripheral name ﬁeld, enter the Peripheral name from the Conﬁguration Manager (use

the PG Explorer tool to view the Peripheral name).

Step 3

In the Peripheral ID ﬁeld, from the Peripheral record, enter the Peripheral ID value from the

Conﬁguration Manager (use the PG Explorer tool to view the Peripheral ID).

Step 4

To provide full functionality, the PIM must establish a connection to the Aspect Application

Bridge. Enter the port number for this connection (from the Aspect Data Link conﬁguration

table) in the App port ﬁeld.

Step 5

Do not check the Offered by service option unless your ICM support provider tells you

otherwise. This option prevents the PIM from gathering statistics about individual ICM routes.

Note: After you ﬁnish installing the PG, you may wish to install the Aspect Application Bridge

Server.