Manual

Expressway-C Expressway-E
Rule name Enter Route to VCS Not applicable
Description Enter Search VCS neighbor zone
Priority Enter 100
Protocol Any
Source Any
Request must be authenticated No
Mode Alias pattern match
Pattern type Suffix
Pattern string Enter @vcs.domain
Pattern behavior Leave
On successful match Continue
Target Neighbor zone to VCS
State Enabled
4. Click Create search rule.
SIP trunks to Unified CM
To configure a SIP trunk to Unified CM, see Cisco Unified Communications Manager with Expressway
Deployment Guide.
Task 13: Configuring logging (optional)
The following configuration will enable event logs to be sent to an external logging server (using the SYSLOG
protocol).
n The Log level controls the granularity of event logging. 1 is the least verbose, 4 the most.
n A minimum log level of 2 is recommended, as this level provides both system and basic signaling message
logging.
Expressway-E external logging server configuration requires additional firewall / NAT configuration – See
Appendix 3: Firewall and NAT settings [p.42].
To configure a logging server:
1. Go to Maintenance > Logging.
2. Configure the fields as follows:
Expressway-C Expressway-E
Log level 2 2
Remote syslog server 1: Address Enter 10.0.0.13 Enter 10.0.0.13
Remote syslog server 1: Mode IETF syslog format IETF syslog format
Cisco Expressway Basic Configuration Deployment Guide (X8.5.2) Page 30 of 57
Optional configuration tasks