Manual

3. Click Save.
Expressway-C
Expressway-E
To create the search rules to route calls to IP addresses to the Expressway-E:
1. Go to Configuration > Dial plan > Search rules.
2. Click New.
3. Configure the fields as follows:
Expressway-C Expressway-E
Rule name Enter External IP address search rule Not applicable
Description Enter Route external IP address Not applicable
Priority Enter 100 Not applicable
Protocol Any Not applicable
Source Any Not applicable
Request must be authenticated No Not applicable
Mode Any IP address Not applicable
On successful match Continue Not applicable
Target Traversal Zone Not applicable
State Enabled Not applicable
4. Click Create search rule.
Cisco Expressway Basic Configuration Deployment Guide (X8.5.2) Page 25 of 57
Routing configuration