User Guide

3-13

AsyncOS 9.1.2 for Cisco Email Security Appliances User Guide

Chapter 3 Setup and Installation

Using the System Setup Wizard

• Accessing the Web-Based Graphical User Interface (GUI), page 3-15

• Defining Basic Configuration Using the Web-Based System Setup Wizard, page 3-16

• Setting up the Connection to Active Directory, page 3-24

• Proceeding to the Next Steps, page 3-24

• Accessing the Command Line Interface (CLI), page 3-25

• Running the Command Line Interface (CLI) System Setup Wizard, page 3-25

• Configuring your system as an Enterprise Gateway, page 3-39

You must use the System Setup Wizard for the initial setup in order to ensure a complete configuration.

Later, you can configure custom options not available in the System Setup Wizard.

You can run the System Setup Wizard using a browser or the command line interface (CLI). For more

information, see Accessing the Web-Based Graphical User Interface (GUI), page 3-15 or Running the

Command Line Interface (CLI) System Setup Wizard, page 3-25

Before you begin, complete the prerequisites at Preparing for System Setup, page 3-8.

Caution If you are setting up a virtual Email Security appliance, you will have to use the loadlicense command

to load your virtual appliance license before running the System Setup Wizard. See the Cisco Content

Security Virtual Appliance Installation Guide for more information.

Caution The System Setup Wizard will completely reconfigure your system. You should only use the System

Setup Wizard the very first time you install the appliance, or if you want to completely overwrite your

existing configuration.

Caution The Email Security appliance ships with a default IP address of 192.168.42.42 on the Management

port of all hardware except C170 and C190 appliances, which use the Data 1 port instead. Before

connecting the appliance to your network, ensure that no other device’s IP address conflicts with this

factory default setting. If you are configuring a Cisco Content Security Management appliance, please

see Centralizing Services on a Cisco Content Security Management Appliance, page 42-1.

IPv6 Address / Prefix:

Fully Qualified Hostname:

Message Security

SenderBase Reputation Filtering: Enable / Disable

Anti-Spam Scanning Engine None / IronPort

McAfee Anti-Virus Scanning Engine Enable / Disable

Sophos Anti-Virus Scanning Engine Enable / Disable

Outbreak Filters Enable / Disable

Table 3-3 System Setup Worksheet: 1 Listener for All Email Traffic (continued)