Technical References

3-132
CLI Reference Guide for AsyncOS 9.7 for Cisco Email Security Appliances
Chapter 3 The Commands: Reference Examples
Mail Delivery Configuration/Monitoring
Cluster Management: This command is restricted to machine mode..
Batch Command: This command does not support a batch format.
Example
In the following example, an older message is archived:
mail3.example.com> archivemessage
Enter the MID to archive.
[0]> 47
MID 47 has been saved in file oldmessage_47.mbox in the configuration
altsrchost
Description
Configure Virtual Gateway(tm) mappings.
Usage
Commit: This command requires a ‘commit’.
Cluster Management: This command can be used in all three machine modes (cluster, group, machine).
Batch Command: This command does not support a batch format.
Example
In the following example, the altsrchost table is printed to show that there are no existing mappings.
Two entries are then created:
• Mail from the groupware server host named @exchange.example.com is mapped to the PublicNet
interface.
• Mail from the sender IP address of 192.168.35.35 is mapped to the AnotherPublicNet interface.
Finally, the
altsrchost mappings are printed to confirm and the changes are committed.
mail3.example.com> altsrchost
There are currently no mappings configured.
Choose the operation you want to perform:
- NEW - Create a new mapping.
- IMPORT - Load new mappings from a file.
[]> new
Enter the Envelope From address or client IP address for which you want to set up a
Virtual Gateway mapping. Partial addresses such as "@example.com" or "user@" are allowed.
[]> @exchange.example.com
Which interface do you want to send messages for @exchange.example.com from?
1. AnotherPublicNet (192.168.2.2/24: mail4.example.com)
2. Management (192.168.42.42/24: mail3.example.com)