Installation Guide

Chapter 6 Service and Maintenance
342 OL-31086-01
Alarm
Message
Type
Message
Cause/Remedy
Description
Severity
ID
IP FEC Failure
(D9854-I only)
Set
FEC Encoder
Failure : FEC
bypassed
Cause: FEC FPGA
malfunction.
Remedy: Reboot
the system if FEC
is needed,
otherwise the
system will
continue to
operate bypassing
FEC.
This fault is
raised when
the FEC
Encoder or the
FEC Decoder
Lockup is
detected.
Major
95000
IP FEC Failure
(D9854-I only)
Set
FEC Decoder
Failure : FEC
bypassed
Cause: FEC FPGA
malfunction.
Remedy: Reboot
the system if FEC
is needed,
otherwise the
system will
continue to
operate bypassing
FEC.
This fault is
raised when
the FEC
Encoder or the
FEC Decoder
Lockup is
detected.
Major
95000
IP FEC Failure
(D9854-I only)
Clear
Fault Cleared
–
The fault is
cleared if the
FPGA recovers
from lockup.
Major
95000
ETH Stack
Filters (D9854-I
only)
Set
HW Error
Detected
Cause: Incoming
traffic causes ETH
Stack Filters to
malfunction.
Remedy: If the
hardware
supports stack
filters reset,
normal operations
continue.
Otherwise, the
unit will reboot.
This alarm is
triggered when
the ETH Stack
Filters
hardware
detects an
internal error.
Major
97000
ETH Stack
Filters (D9854-I
only)
Clear
Fault Cleared
–
The fault is
cleared when
the detected
hardware error
is resolved.
Major
97000