Installation Guide

Chapter 6 Service and Maintenance
340 OL-31086-01
Alarm
Message
Type
Message
Cause/Remedy
Description
Severity
ID
FEC FPGA
Status
(D9854-I only)
Set
Failed to find or
load FEC FPGA
binary
Cause: Cannot
find the FEC
FPGA file in the
USB FLASH, or it
failed to open,
read, or load the
file to the FEC
FPGA.
Remedy: Ensure
that the USB
FLASH is
installed,
formatted, and the
image is loaded.
Also, ensure that
the FEC FPGA is
installed and the
CPLD is properly
programmed.
The FEC FPGA
image is not
found in the
USB FLASH, or
the file cannot
be loaded to
the FEC FPGA
for any reason.
This will occur
in production
until the USB
FLASH is
installed,
formatted, and
the image is
loaded.
Major
92400
FEC FPGA
Status
(D9854-I only)
Set
FEC FPGA failed
to start
Cause: Hardware
issue.
Remedy: Ensure
that the USB Flash
is installed,
formatted, and the
image is loaded.
Also, ensure that
the FEC FPGA is
installed and the
CPLD is properly
programmed.
FEC FPGA is
loaded, but
failed to start
(not ready).
Major
92400
FEC FPGA
Status
(D9854-I only)
Set
FEC FPGA access
failed
Cause: Hardware
issue.
Remedy: Ensure
that the USB Flash
is installed,
formatted, and the
image is loaded.
Also, ensure that
the FEC FPGA is
installed and the
CPLD is properly
programmed.
FEC FPGA is
loaded and
started,but
attempt to read
configuration
registers failed.
Major
92400