Installation Guide

Configuring Transport Stream Information
OL-31086-01 241
Stream Details
Description
Encapsulation
Selects the transport protocol to use for the output stream (UDP or
RTP).
Destination IP
Enter the unicast (valid host IP only) or multicast destination IP
address.
Destination UDP
Port
This selects the destination port number (1 to 65534).
Note: If you selected RTP for Encapsulation, you must choose an
even destination port number.
2 To modify the stream information, click the radio button of a stream and click
Edit.
3 Make the necessary changes and click Save.
4 To configure advanced stream settings, click a radio button of a stream and click
Advanced.
The following table describes the advanced settings:
Advanced Settings
Description
Traffic Class
Sets the quality of service (0 to 255).
Time to Live (Max #hops)
This sets the hop limit of the packet's lifespan (0 to 255).
Source UDP Port
This sets the source UDP port number (0 to 65535).
Note: Set the Source UDP Port to 0 to use the default UDP
port (49162).
Announce Type
Choose RFC 2327 to send the Session Announcement
Protocol (SAP) messages according to the RFC 2327 standard.
Otherwise, choose None to not send SAP messages.
Announce Title Source
Choose User String to use the SAP string as the channel
name, defined in the Announce User's Title below.
Otherwise, choose SDT channel to use the SDT string as the
channel name.