Installation Guide

Configuring Transport Stream Information
OL-31086-01 233
Output Mode
Description
Full DPM Control
The output will be generated according to the DPM settings on the
MPEG over IP Digital Program Mapping page. This is a manual
control setting.
SPTS Service
Channels Only
(D9854-I only)
The service channel is passed with the same channel number,
PMT PID, and ES PID numbers.
SPTS MAP Service
Channels Only
(D9854-I only)
The service channel is mapped to the preconfigured channel
number, PMT, and ES PIDs.
SPTS Full DPM
Control (D9854-I
only)
The output will be generated according to the DPM settings on the
MPEG over IP Digital Program Mapping page. This is a manual
control setting.
A message appears to confirm that you want to resynchronize the output
changes and PIDs to match the selected input programs. Click Yes.
If a conflict occurs and Enable Auto Map for Collision is set to No, a detailed list
of all the conflicts is displayed in the Output Channel and PID Conflicts table
when you click View Conflicts. You can then resolve the conflicts manually. If a
conflict occurs and Enable Auto Map for Collision is set to Yes, a message that
the conflicts will be fixed automatically and the Output Channel and PID
Conflicts table is empty.
 For channel conflicts, the system will only automatically change the
duplicated output channel numbers. If both PE actions are set to Map, the
output channel number of the higher PE is changed. Otherwise, the output
channel number of the mapped PE is changed. The new channel number
selected is the next channel number that does not appear in the current PAT
or belong to any other PEs.