Installation Guide

Configuring Transport Stream Information
OL-31086-01 231
The following MPEG over IP Output page is displayed for the D9854:
Note: Any changes made to the MOIP DPM values will automatically change the
Mode Status to Edited by User.
2 From the Rate Control drop-down list, choose the MOIP output rate control. The
following table describes the affect each of the settings has on the output bit rate:
Rate Control
Description
Auto
The output rate follows that set by the uplink. This setting can be
used if the signal source is ASI. If Null Packet Insertion is set to
Yes, the output bit rate is the same as the input rate (including all
the null packets). If Null Packet Insertion is set to No and the
Output Mode is set to one of the MPTS modes, the output rate is
equal to the payload rate of the transport stream to be
encapsulated, and in most cases, it will be lower than the overall
input rate.