Installation Guide

Setting up Input Information
OL-31086-01 175
Setting up SI Receive Parameters
1 From the user interface of the D9854/D9854-I, choose Input > SI Receive Setup.
The SI Receive Setup page is displayed.
2 In the Custom Tuning Mode area, from the Acquisition Mode drop-down list,
choose the tables required for the service list creation and signal acquisition. The
selections are Auto, Basic, or Custom. The default is Basic. If you choose Basic, it
requires NIT to be present. If you choose Auto, it uses all the available service list
tables and it will acquire if any table is present.