Installation Guide

Setting up Input Information
OL-31086-01 171
d Click Save.
e Click OK. You can add up to 8 IP addresses.
8 Click Apply.
Configuring IP De-Jittering
The de-jittering engine has the ability to de-jitter two streams simultaneously (from
Data1 and Data2 ports), based on the selected PCR PID for each stream.
1 In the Input Setup page (Input > Input Setup), click the IP tab. Refer to the De-
Jitter Configuration area.
2 From the Algorithm drop-down list, choose the de-jittering algorithm (VBR or
CBR).
3 Set the de-jittering buffer Latency (delay), in milliseconds. If VBR is selected, you
can enter a range from 110 to 150 milliseconds to set a high buffer latency. If CBR
is selected, you can enter a range from 40 to 150 milliseconds, to set a lower
latency for CBR streams.
Setting Up Redundancy Controls for MPEG over IP Input
The Redundancy Configuration area allows you to configure redundancy for MPEG
over IP input when an active port fails due to one of the monitored error conditions
(triggers). The data port 1 is labeled as TS 2 and data port 2 is labeled as TS 3 on the
rear connector panel. For more information, see D9854/D9854-I Receiver Rear
Connector Panel (on page 28).
1 In the Input Setup page (Input > Input Setup), click the IP tab. Refer to the
Redundancy Configuration area.