Installation Guide

Chapter 5 Web GUI Setup and Monitoring
170 OL-31086-01
If the FEC Mode is set to 2D, in addition to entering the FEC columns port
number, enter the FEC destination UDP port number of the row FEC stream in
the FEC Rows Port field (2 to 65534, even only). We recommend that you set the
rows port number to TS Destination Port + 4.
7 From the Source Filter drop-down list, choose the source (host) filtering mode
(None, White List, or Black List).
Note: Source filtering also applies to IGMP (v3 only). For more information, see
Protocol Control Settings.
The incoming streams are always filtered based on user-configured destination
information (destination IP address and UDP ports). In addition, they can be
filtered based on selected Source Filter mode.
Choose None to receive streams without source restrictions.
Choose White List to only allow streams from the defined list of hosts/servers.
Choose Black List to allow streams from any host/server, except for the ones
defined in the list of hosts/servers.
The list of hosts/servers is defined in the Source Filter Setup window. To define
the hosts/servers:
a Click Source Filter Setup. The Source Filter dialog box opens.
b Click Add Row.
c If White List is selected as the Source Filter, enter the IP address of a trusted
server the unit is allowed to receive streams. The unit is allowed to receive
streams from servers with IP addresses listed here.
If Black List is selected as the Source Filter, enter the IP address of a server
that is not trusted. The unit is allowed to receive streams from any server,
except for the servers with IP addresses listed here.