Installation Guide

Chapter 5 Web GUI Setup and Monitoring
168 OL-31086-01
2 Click the IP tab.
3 In the MOIP Input Selection area, check the Use MOIP Input check box to tune
to the MPEG over IP Input.
Note: Setting a new input to be active will deactivate the currently active input.
4 From the Source IP Selection Mode drop-down list, choose UserCfg to lock to
the source IP input set by the user, or choose SW Map to automatically detect
and select which stream to tune to.
5 If UserCfg is selected as the Source IP Selection Mode, click User Selected
Source IP to select the data 1 or data 2 streams.