Installation Guide

Chapter 5 Web GUI Setup and Monitoring
164 OL-31086-01
Select Reacquire Tuning & Channel List Only for the decoder to tune back to the
user configured input and frequency and re-acquire the PSI/SI information back to
the selected channel. Click OK.
Note: This operation can take several minutes, depending on the size of the network.
Viewing the Current Input Status
The Current Input Status section displays the current RF status.
The following table describes the Current Input Status information displayed:
Parameter
Description
Frequency (GHz)
The current downlink frequency, in GHz.
L band Freq. (MHz)
The current L-Band frequency, in MHz.
Symbol Rate (Msym)
Symbol rate of the received signal, in Msymbols/second.
FEC Rate
The FEC (Forward Error Correction) rate of the received signal
(N/A, 1/2, 3/5, 2/3, 3/4, 4/5, 5/6, 7/8, 8/9 or 9/10).
Signal Status
Indicates whether the input signal is locked.
 Locked - Indicates the receiver is locked to a carrier
with no valid content.
 Lock+Sig - Indicates the receiver is locked to a carrier
with valid content.
 No Lock - Indicates the receiver is not locked to a
carrier.
AFC (MHz)
Indicates the current Automatic Frequency Control count, in
MHz.
Acquisition State
Displays Full if the SI and PSI tables have all been found.
Otherwise, it will display Degraded if there are missing tables or
None if no SI or PSI tables have been found.
Orbital Validation Status
Displays the status of the last user orbital validation performed.
It displays Passed if the last orbital validation was successful or
None if a orbital validation was never performed. Otherwise, it
will display a reason for the failed validation.