Installation Guide

Chapter 4 Front Panel Operation
98 OL-31086-01
Menu Item
Description
Parameters
Right (dB)
Sets the volume adjustment for the
Right audio channel, in dB.
-6.0 to +6.0
Any value can be entered with the
numeric keypad (in the appropriate
range), but the UP and DOWN
arrows will increase or decrease in 0.5
dB steps.
DDP (D9854 with
SDI only)
Sets the Dolby Digital Plus output
mode. If Trans is selected, it will
transcode to Dolby Digital (AC-3)
audio output. If Passthrough is
selected and the bitrate is less than
1536 kbps (48 Khz), passthrough is
performed and Dolby Digital Plus
compressed out is received. If
Passthrough is selected and the
bitrate is more than 1536 Kbps,
transcoding will be performed. This
setting affects only the AES-3id and
SDI outputs.
Note: Dolby Digital Plus is only
available on Audio 1. Ensure that
the Aud# is set to Aud1.
Note: Ensure that the Digital Out
Pref is set to Compressed for digital
passthrough. Otherwise, only
decoded PCM will be available.
This parameter has no effect if the
audio source is not Dolby Digital
Plus.
Trans (Transcoded) or Pass
(Passthrough)
Digital Out Pref
(D9854 with SDI
only)
Sets the output preference for the
SDI output or AES-3id output.
PCM Samples - If the audio source is
MPEG Layer II format, the output
will be routed to the SDI output as
PCM.
Compressed - If the audio source is
AES compressed, the output will
routed to the AES-3id output,
compressed.
Select Language By
Method of selecting the audio PID
for the local audio decoding. This is
required if the monitored program
contains more than two audio PIDs.
PMT Order (default) - Allows you to
select a PMT order.
Language List - Allows you to select a
language from the available list.
Language Entry - Allows you to enter
a language code.