Release Notes

DescriptionBug ID
FEC latency values differ from the source.CSCva66760
IP1 does not work with UDP ports below 6000.CSCva68371
SD output status is incorrect when it is set to PAL-M or PAL-N.CSCva69910
Subtitle occasionally displays one duplicate line at the top of the screen.CSCva74188
Unit reboots every few minutes, depending on the frequency and type of subtitle
packets.
CSCva76027
Some EIA 608/708 closed caption streams do not display closed captions.CSCva78318
Startup requests from the front panel may be ignored by the application.CSCva82886
AMOL II does not appear on CVBS or SDI.CSCva82891
Cannot set all possible GMT offsets.CSCva84332
VBI, CC, and VANC line drop during loopback.CSCva93206
SDI 1 video input format incorrect after reboot.CSCva93658
VBI lines missing with dual VBI content.CSCva97175
OSD message not displayed on the output.CSCva97486
Following IP protocols, HTTP/HTTPS, SNMP, and IGMP may not be enabled
or disabled, as shown on the web GUI.
CSCvb06305
Imitext subtitle option plays DVB subtitles.CSCvb11939
Output channel number and PMT PID cannot be set to 1 on the DPM page.CSCvb14827
New subtitle messages replace the old one immediate, rather than a small period
of no subtitle displayed.
CSCva88890
Unit does not tune to an alternate channel when scheduled replacement event
is generated.
CSCvb20539
No programs on IP output after power up with CAM inserted.CSCvb22492
Input not acquired when switching between ASI and RF with CAM inserted.CSCvb26361
D9800 Version 1.00 restarts at random, during normal use.CSCva22230
IP Input dejitter fails after a period of time.CSCuz62569
Release Notes for Cisco D9800 Network Transport Receiver Version 1.10
3
Introduction
Resolved Caveats - Version 1.10