Installation Guide

12
Cisco 2-Channel SFP-Based Wavelength Converter Installation Note
78-16648-01
Installing the 2-Channel SFP-Based Wavelength Converter
Figure 3 Installing a 2-Channel SFP-Based Wavelength Converter
Step 3
Gently push the converter chassis into the open slot in the 2-slot chassis. Ensure that you line up the
captive screws on the converter with the screw holes on the 2-slot chassis.
Step 4 Continue pushing the converter chassis into the open slot until the converter chassis faceplate makes
contact with the 2-slot chassis faceplate.
Step 5 Tighten the two captive screws with the Number 2 Phillips screwdriver. Do not cross-thread or
overtighten the captive screws.
Step 6 Attach a system ground wire to the chassis ground connection. (See Figure 4.)
Figure 4 AC In and Chassis Ground Connections
Step 7
Attach the AC power cord to the AC In connector on the converter chassis. (See Figure 4.) Connect the
other end of the power cord to source AC.
130168
130169
Site source AC
Site system ground