Installation Guide

11
Cisco 2-Channel SFP-Based Wavelength Converter Installation Note
78-16648-01
Installing the 2-Channel SFP-Based Wavelength Converter
Figure 2 Mounting the 2-Slot Chassis in the Rack
Installing the 2-Channel SFP-Based Wavelength Converter
Caution When performing the following procedures, wear a grounding strap around your wrist to avoid ESD
damage to the converter. Make sure that the other end of the ground strap is securely attached to a
grounded point.
To install the 2-Channel SFP-Based Wavelength Converter in the 2-slot chassis, follow these steps:
Step 1 Remove the converter from its packaging.
Step 2 Align the converter chassis with the open slot in the 2-slot chassis. (See Figure 3.)
68818