Reference Guide

Cisco Prime Network Analysis Module Command Reference Guide Page 99
monitor data-aggr-intv
To set data aggregation intervals, use the monitor data-aggr-intv command. This command is added
in NAM 6.0(1).
Monitor data-aggr-intv
Defaults
This command has no default settings.
Command Modes
Command mode
Usage Guidelines
When you enter the monitor data-aggr-intv submode, the following commands are available:
 ?—Displays help. (Added in 6.0(2)
 cancel—Discards changes and exits from the subcommand mode.
 exit—exits from the subcommand mode.
 help—Displays help.
 hosts-user-defined enable—enable user-defined hosts.
 hosts-user-defined disable—disable user-defined hosts.
 intf-stats-polling— enable or disable managed device interface stats polling. (added in 6.0(2))
 long-term-intf [min]—Specify long term interval for managed device interface stats (min).
 long-term-rsp-time [min]—Specify long term interval for application response time (min).
 long-term-traffic [min]—Specify long term interval for traffic (min).
 short-term-intf [min]—Specify short term interval for managed device interface stats (min).
 short-term-rsp-time [min]—Specify short term interval for application response time (min).
 short-term-traffic [min]—Specify short term interval for traffic/media (min).
Examples
This example shows how to set data aggregation intervals:
[e-mail]# monitor data-aggr-intv
Entering into subcommand mode for this command.
Type 'exit' to apply changes and come out of this mode.
Type 'cancel' to discard changes and come out of this mode.