Reference Guide

Cisco Prime Network Analysis Module Command Reference Guide Page 95
 short-term-rsp-time [min]—Specify short term interval for application response time (min).
 short-term-traffic [min]—Specify short term interval for traffic/media (min).
Examples
This example shows how to set data aggregation intervals:
[e-mail]# monitor data-aggr-intv
Entering into subcommand mode for this command.
Type 'exit' to apply changes and come out of this mode.
Type 'cancel' to discard changes and come out of this mode.
[e-mail](sub-data-aggr-intv)
# [e-mail](sub-data-aggr-intv)# ?
? - display help
cancel - discard changes and exit from subcommand mode
exit - exit from the subcommand mode
help - display help
hosts-user-defined - collect only hosts from user-defined sites
long-term-intf - specify long term interval for managed device interface stats (min)
long-term-rsp-time - specify long term interval for application response time (min)
long-term-traffic - specify long term interval for traffic (min)
short-term-intf - specify short term interval for managed device interface stats (min)
short-term-rsp-time - specify short term interval for application response time (min)
short-term-traffic - specify short term interval for traffic/media (min)
[e-mail](sub-data-aggr-intv)#
 monitor nbar
 monitor protocol encapsulation
 monitor rtp-stream enable
 monitor rtp-stream filter
 monitor rtp-stream threshold
 monitor urlcollection
 monitor urlfilter
 netflow input port
 nslookup
 password
 password strong-policy
 patch
 pid-sn
 ping
 preferences
 protocol esp-null-heuristic