Reference Guide

Cisco Prime Network Analysis Module Command Reference Guide Page 93
managed-device community
To configure the managed device SNMP community, use the managed-device community
command. To remove the managed device community string, use the no managed-device community
command. This remove command is added in NAM 6.0(1).
No managed-device community
managed-device community <rw-community>
Note This command is not supported on NAM-1, NAM-2, NME-NAM-80S,
NME-NAM-120S and the NAM Virtual Blade devices.
Syntax Description
rw-community
Specifies the SNMP community for read/write
operations.
Syntax Description
Defaults
None.
Command Modes
Command mode
Usage Guidelines
This command is supported only on Cisco NAM 2200 Series appliances.
Examples
The following example sets the managed-device community:
[e-mail]# managed-device community
[e-mail]#
[e-mail]# no managed-device community
Managed Device Community string removed if any!
[e-mail]#